BASE CIRCUIT IN PC1D SIMULATOR SOFTWARE

Hold your mouse over any terminal of any component.Search can help you rapidly create components:.press / (frontslash) to bring keyboard focus to the search box.start typing in the search box at the top of the toolbox, or.click the component in the toolbox, and then click in the schematic.drag the component from the toolbox to your schematic, or.First, use the mousewheel or two-finger scroll to scroll within the toolbox on the left until you find the component youвЂ™d like.Finally, single-click on any blank space in the schematic to close the properties sheet.Change the C parameter, short for вЂњCapacitanceвЂќ, to 22m / 2, and observe the change on the schematic.Change the DISP parameter, short for вЂњDISPlay typeвЂќ, to вЂњPolarizedвЂќ, and observe the change on the schematic.right-click on capacitor C1 and use the Edit Parameters option in the context menu.First, double-click on capacitor C1 to bring up the properties sheet, or.To modify a componentвЂ™s value or appearance:.right-click and use the Undo option in the context menu.right-click and use the Delete option in the context menu.use the Delete option in the Edit menu, or.press Backspace or the Delete key to delete it, or.right-click and use the Flip Horizontally or Flip Vertically options in the context menu.right-click and use the Rotate CW or Rotate CCW options in the context menu.press Shift+R to rotate counterclockwise, or.First, single-click on resistor R1 to select it.To disable this feature if itвЂ™s not doing what youвЂ™d like, just tap the Alt (or Option, or Esc) key once while dragging.

BASE CIRCUIT IN PC1D SIMULATOR SOFTWARE

Notice that the software keeps the wires connected intelligently.click and drag the bottom-most horizontal wire, and move it a few grid lines further down.click and drag on voltage source V1, and move it a few grid lines to the left.switch to Pan mode using the bottom-left button within the CircuitLab window.hold the middle mouse button (press mousewheel) and drag, or.hold the Ctrl (or Command) key while using your primary mouse button to drag, or.use the Zoom In, Zoom Out, or Zoom to Fit options in the Edit menu.use the zoom in/out controls in the bottom right of the CircuitLab window, or.use the Ctrl-Plus or Ctrl-Minus keyboard shortcuts (Command-Plus or Command-Minus on macOS), or.use a two-finger drag up or down on your touchpad, or.Exercise Click the circuit above and follow the steps below to quickly learn the user interface.

Base circuit in pc1d simulator